How To Repair Your Garage Door Seal

How To Repair Your Garage Door Seal

What’s the point of a garage door seal? It protects your car and home from the weather! But did you know that it also needs to be watertight, or else rainwater can get in? Other things that can get in are bugs, snakes, insects, and other pests if not sealed correctly. You should check for leaks around seals where there are gaps between floorboards with wood glue (or epoxy) before driving season starts so we don’t have any problems during winter months when temperatures drop below freezing at nighttime.

Rubber garage door seal prevents debris and water from entering your home. It also keeps the snow, rain, and pests out while maintaining a tight closure that can withstand drastic weather changes such as expansion or contraction due to the heating system used in winter months when it expands more than usual but contracts during cooling periods where there’s less airflow through doors for example- this is why you may notice light coming into areas near damaged parts! If any part of your present seal shows signs of wear & tear (or if it’s just not performing properly), don’t hesitate: contact an expert who will provide fast service at affordable rates.

If you have problems with your garage door seal, here is how to fix it.

1. Measure the garage door for the length of gasket needed

To find the right rubber seal for your garage door, you’ll need to get measurements of its width, height, and thickness.

2. Buy a new garage door seal

The best way to tell you to have a good seal on your garage door is by looking at it. If there’s no gap between where the bottom of one piece meets with another, then congratulations! You’re all set up for winter weather and can leave those doors open if necessary this year without worrying about them being closed from underneath due to snowfall weight. ‍It may seem difficult but measuring first will help make sure that every inch has been covered so nothing gets left out or missed during installation time.

3. Remove the old garage door seal

Lift the door slightly and slide out your old rubber gasket from the bottom of it. If you meet any resistance, check if this is because there may be nails or staples holding onto weather stripping at the garage doors edge which needs to come off for smoother passage through objects on either side with a flat-head screwdriver or hammer as needed before removing them after the examination has been made sure that no obstacles remain in order for things like cars being able to drive up next time around so they can leave without having trouble sparking where ever possible due too slippery surfaces. For ease of maintenance going forward, it may be in your best interest to install a new aluminum track so as not to put unnecessary holes through the bottom panel.

4. Replace the garage seal

With the new rubber seal in place and pulled tight across your door, you’ll need to gently thrust it into position. Some people find dish soap helps them grip better when their hands become slippery from all that tugging; others have a more difficult time because of this slipperiness issue- though any kind should work as long as it’s applied gently! Once inside track looks up at where those pesky numbers were affixed before slowly lowering yourself down again until everything locks back together seamlessly above ground level.

If you need to replace the garage door gasket, otherwise known as a seal for your doors it is an easy project. If not know what you are doing or have plenty of time call our San Antonio garage repair company today or you can also visit our local office in San Antonio to discuss your garage door repair project.

GET A FREE QUOTE

LATEST POSTS

Call Now Button Skip to content